Cracked panes, fogged units, or shattered door lites don’t just look bad—they impact safety, energy performance, and customer confidence. Our commercial glazing team restores clear views and reliable security with prompt diagnostics, clean craftsmanship, and materials matched to your location and traffic.
From small impact damage to full panel failures, we handle measurement, sourcing, installation, and cleanup while keeping your entrance operational and your brand looking sharp.
When to Repair vs. Replace
Not every issue needs a full rebuild. We evaluate frame condition, glass type, and exposure to recommend the most sensible fix for long-term performance and cost control.
| Situation | Recommended | Reason |
|---|---|---|
| Minor chips, edge scratches | Localized repair | Restores appearance and safety without downtime |
| Fogging in insulated units | IGU replacement | Fixes failed seals and thermal loss |
| Breakage on doors or near floor | Tempered/laminated replacement | Meets safety glazing codes and resists impact |
| Repeated vandalism or high risk | Laminated or security laminate | Better intrusion delay and sound reduction |
Emergency Board-Up & Same-Day Stabilization
We secure the opening, sweep and contain glass safely, and protect merchandise and foot traffic. Precise measurements are taken on the spot so fabrication begins immediately, and we schedule installation to minimize disruption to your hours.
Temporary door panels, acrylics, or safety film can be used where appropriate to keep the entrance serviceable until the permanent glass arrives.
Glazing Options That Work Hard
Choose from tempered or laminated safety glass, low-iron for truer color on displays, and low-E or solar-control coatings for bright exposures. For added protection, ask about security interlayers or film that increase hold-together performance without sacrificing visibility.
Door lites, sidelites, and transoms are matched to your frame system and hardware clearances to ensure smooth operation and a tight weather seal.
What We Service
We work across retail, restaurants, offices, and multi-tenant buildings, coordinating with property managers and GC teams when needed.
- Single panes, IGUs, and oversized storefront panels
- Aluminum frames, narrow and wide stile doors
- Sidelites, transoms, vestibules, and bulkhead glass
- Hardware tune-ups: closers, pivots, continuous hinges, and locks
Our Step-by-Step Process
- Assessment & Quote: We identify root causes—seal failure, impact, settlement—and present clear options.
- Measure & Order: Glass is specified for thickness, tint, temper/lamination, and coatings, then ordered to size.
- Removal & Prep: We deglaze safely, clean channels, true frames, and set new setting blocks and shims.
- Install & Seal: Panels are set plumb and square, glazed, and caulked with commercial-grade sealants.
- Final Tune & Clean: We align doors, verify weathering, clean glass, and hand over care guidance and warranty.
Code, Safety & Accessibility
We use safety glazing in required locations and confirm proper hardware heights, clear openings, and thresholds for accessibility. Where permitting or drawings are needed, we supply documentation to streamline approvals.
If your façade faces strong sun or busy streets, we balance performance and appearance with the right make-up to manage heat, glare, and noise.
Care Tips After Service
Keep weep holes clear, avoid abrasive cleaners, and schedule seasonal closer adjustments if door speed changes. Early attention to drafts or latch misalignment prevents premature wear and protects energy performance.
Branding films and manifestation bands can be re-applied or upgraded during service to refresh the look and improve visibility for customers.
Book Your Service Today
If you need fast, professional Storefront Windows and Doors Glass Repair & Replacement with minimal downtime and maximum polish, schedule a site visit. We’ll restore your view, security, and customer-ready appearance—without interrupting the flow of business.
